wedge wire screen,wedge wire screens,wedge wire screen manufacturers

Email us now

Factors to be considered when installing stainless steel mining vibrating screen plate

Stainless steel mining vibrating screen plate is the inevitable product of the refinement of coal, iron ore, industrial and chemical raw materials, and it is the component of the microcells of social development, which indirectly or directly affects the development of society. The selection of stainless steel mining vibrating screen plate is mainly based on the characteristics of the screen.
Before purchasing the stainless steel mining vibrating screen plate, the width of the screen machine shall be well done first, and then the width of the screen machine shall be about 50 mm wider than that of the screen machine when the screen is planted and cut so that it is easy to install. 304 or 316L shall be selected as far as possible when selecting the screen mesh normally. If the cost of stainless steel mining vibrating screen plate is too high due to the large screen mesh diameter, manganese steel or materials with higher hardness shall be selected. It is not recommended to select Q235 screen mesh because it is easy to deform. When the installed stainless steel mining vibrating screen plate wire diameter is too small, a layer of trawl shall be added to the screen to increase the service life of the surface screen. Generally, trawls shall be added above 60 mesh.
During the installation of the grid, it is required to distinguish the front from the back, and pay attention to the front and back alignment of the wooden grid. The upper and lower parts shall be compressed tightly. When installing according to the requirements, the grid shall be lightly hit with a rubber hammer. Pay attention to tighten the screws of the grid structure, otherwise, it will cause material leakage. When installing the stainless steel mining vibrating screen plate, pay attention to the tightness of the screen. The loose materials will stop rotating in place, and the tightness of the over tight screen which is easy to break should be appropriate.
The above is related to stainless steel mining vibrating screen plates. I hope it can help you. If you need a stainless steel mining vibrating screen plate, please contact us.

You may also be interested in the following product(s)

Skype
Message
Email
Contact Us
Name:Anna
Tel:+86 311 8595 5658